###3D Printer I have been collecting parts for a 3D printer wherever I can find them (junk printers, scrap lumber). I have collected steppers, smooth rods, threaded rods and some wood. So now my next steps are to design the chassis and drive mechanisms. I had this drawn on a sheet of paper but have misplaced that paper. I am going to look at using a high strength fishing line to drive the X and Y axis.

Going foward:

  • Create an accurate drawing with measurements
  • Acquire components to move X and Y axis
  • Test electronics

Items to acquire:

  • Hotend (J-Head most likely)
  • High tensile strength nylon fishing line

When I am finished I hope to end up with something that looks similar to this: Wolfstrap